Lazer Z X-Series
No maintenance, sealed and non-greasable spindles; 7.75"-diameter cutter housing with 30mm (1.18") diameter spindle shaft, double row bearings, top and bottom, and splined blade driver.
24 x 12.0-12, 4-ply Turf Master®
Unibody, welded, heavy-duty 1.5" x 3" tubular steel.
Hydraulically dampened twin levers, adjust fore and aft. Adjustable dampeners (3 positions) to customize drive responsiveness. Also adjustable to 2 height positions.
Front Caster Tires
13 x 6.5-6, smooth-tread, semi-pneumatic.
Lever-actuated disc brake.
Deluxe, two-tone, bolstered suspension seat with Elastomeric Vibration Control material. Mounted on innovative Seat Isolation System that provides operator isolation in all three planes of motion as well as fore-aft slide and seat flip-up.
12-volt battery with 25-amp alternator.
Engine hour meter and cup holder
Command Pro™ EFI
Electronic Throttle Body
Heavy-duty canister air filtration system
12-gallon (45.4-L), single fuel tank with single fill location.
Yes - electronic Sender
Two Exmark exclusive Parker unitized pump and wheel motor systems with no hoses, integrated cooling fans, shock valve, 1.7-quart integrated reservoir, spin-on filter and heavy-duty components. 16 cc pumps and 17.1 cubic inch motors.
Infinitely variable speed selection from 0–11.5 mph (18.5 kmph) forward, 0–7.0 mph (11.3 kmph) reverse
Standard; foot-controlled deck lift changes cutting height and lifts the deck to maneuver around obstacles, or place in transport position.
Operator Presence Controls (OPC) and drive system interlock, with safety interlock system indicators.
2-post foldable ROPS standard with seat belt and latch.
MagStop Electromagnetic 250-ft-lb clutch with spot brake
Drive Wheel Release
Allows unit movement without engine running.
.50" thick caster yoke arms.
Width / Cutting Deck
Deck Style Description
Full-floating UltraCut Series 6 with heavy-duty spindle. Side discharge standard with the option to bag or mulch.
10-gauge top that is formed and continuously seam welded, 7-gauge side skirt and 7-gauge formed and welded spindle mounting locations for improved strength and reduced weight.
Blade Tip Speed
Approximately 18,500 fpm.
1.0" (2.5 cm) to 5.5" (11.8 cm) in 0.25" (0.64 cm) increments adjustable from operator’s seat.
3 Blades at 20.50" Length
72.8 in. (184.9 cm)
83.1 in. (211.1 cm)
70.5 in. (179.1 cm)